Pelco ERD2000 Uživatelský manuál

IRD/ERD2000 SeriesReceiverC1506M-A (8/02)®INSTALLATION/OPERATION

10 C1506M-A (8/02)FUSE REPLACEMENTCAUTION: These service instructions are for use by qualified service personnel only. Toreduce the risk of electrica

C1506M-A (8/02) 11TROUBLESHOOTINGCheck the wiring connections.If the CX LED does not blink when commands are sent to the receiver, make sure the contr

12 C1506M-A (8/02)WIRING TABLESWire GaugeTable A. 24 VAC Wiring Distances TableThe following are the recommended maximum wire distances (transformer

C1506M-A (8/02) 13SPECIFICATIONSERD2200ElectricalInput Voltage: 115/230 VAC, 50/60 HzOutput VoltageCamera: 24 VAC (or 115/230 VAC if usingenclosure po

14 C1506M-A (8/02)REGULATORY NOTICESNOTE: This equipment has been tested and found to comply with the limits of a Class B digitaldevice, pursuant to

C1506M-A (8/02) 15REVISION HISTORYManual # Date CommentsC1506M 3/00 Original version.C1506M-A 8/02 Revised manual per ECO #02-8195 to meet UL standard

World Headquarters3500 Pelco WayClovis, California 93612 USAUSA & CanadaTel: 800/289-9100Fax: 800/289-9150InternationalTel: 1-559/292-1981Fax: 1-5

2 C1506M-A (8/02)

C1506M-A (8/02) 3CONTENTSSection PageIMPORTANT SAFEGUARDS AND WARNINGS ...

4 C1506M-A (8/02) 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not block any v

C1506M-A (8/02) 5The IRD/ERD2000 Series Receiver operates Pelco’s fixed speed pan/tilts and domes.The receiver works with standard and extended Coaxit

6 C1506M-A (8/02)ERD2200 WIRINGENCLOSUREPOWER OUTLLNNGROUNDSTUDPOWERTERMINALSMAINPOWER INFigure 2. ERD2200 Receiver Figure 3. ERD2200 Power Connecti

C1506M-A (8/02) 7ACAC24V 50/60HZ INPUT POWER ~24V ~50/60HZ P/TPOWER SELECT 115/230V ~50/60HZ ACACERD OPTIONTLCOUTVIDEOINPWR CXLENS AUX1 AUX2 C N NOC24

8 C1506M-A (8/02)IRD2024 WIRING1. Connect power to the 24 VAC INPUT connector on the rear of the receiver. The receiver’s powerrequirement is a maximu

C1506M-A (8/02) 9When power is applied to the receiver, the green PWR LED on the receiver lights.Whenever the receiver gets a valid Coaxitron control