INSTALLATION Heavy-DutySpectra ® IV Series C3419M (8/06)In-Ceiling Back Box

10 C3419M (8/06)SPECTRAADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-871 ON ON ON OFF OFF OFF ON OFF72 OFF OFF OFF ON OFF OFF ON

C3419M (8/06) 11SPECTRAADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8151 ON ON ON OFF ON OFF OFF ON152 OFF OFF OFF ON ON OFF OF

12 C3419M (8/06)SPECTRAADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8223 ON ON ON ON ON OFF ON ON224 OFF OFF OFF OFF OFF ON ON

C3419M (8/06) 13 Specifications GENERAL ConstructionBack Box AluminumDome Drive Aluminum, thermoplasticLower Dome Clear polycarbonate, 0.090-inch th

14 C3419M (8/06)The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/ECTh

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defectivein material or workman

Worldwide Headquarters3500 Pelco WayClovis, California 93612 USAUSA & CanadaTel: 800/289-9100Fax: 800/289-9150InternationalTel: 1-559/292-1981Fax:

2 C3419M (8/06) InstallationBACKMOUNTINGPLATESMOUNTINGRINGCEILING153642

C3419M (8/06) 3 1. Locate the center point of the mounting location and insert the compass tool. Draw a circle.2. Cut the circle out of the ceiling.3

4 C3419M (8/06)78VIDEOUTP+ UTP-RX- RX- TX-TX-PWR- PWR+GNDAUX2GNDGNDNONCCOM7654321ALARMSAUX1

C3419M (8/06) 5 7. Install the back box by compressing the spring clips and pushing the back box through the hole. Tighten the screws until you hear

6 C3419M (8/06)TRIM LEASHBALL STUDBALL STUDRECEIVERBARREL KEY LOCKSWITCH 1 AND 211910

C3419M (8/06) 7 9. Configure DIP switches SW1 and SW2 located on the top of the dome drive. For DIP switch settings, refer to the labels located on th

8 C3419M (8/06) Switch Settings WARNING: If you are using D-type or P-type control, your system may not operate if the baud rate and address switch

C3419M (8/06) 9 Table E. Switch Settings for SW1, P-Type Control NOTE: For Coaxitron controls, SW1 is not used; set all switches OFF. For D-type