Pelco IPSXM-7 Uživatelský manuál

IMPORTANT INSTRUCTIONSO-Ring Installation for ExSiteTM Series Explosionproof Power Module(IPXSM-2 and IPSXM-7)®Pelco World Headquarters: 3500 Pelco Wa

C313M-D (8/05) 9 TablesADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-81 OFF OFF OFF OFF OFF OFF OFF OFF2 ON OFF OFF OFF OFF OFF

10 C313M-D (8/05)ADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-849 ON OFF OFF OFF ON ON OFF OFF50 OFF ON OFF OFF ON ON OFF OFF51

C313M-D (8/05) 11Table B. D Protocol Receiver Address (Continued)ADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8143 ON ON ON ON

12 C313M-D (8/05)ADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8239 ON ON ON ON OFF ON ON ON240 OFF OFF OFF OFF ON ON ON ON241 O

C313M-D (8/05) 13 Specifications ELECTRICAL Input Voltage 24 VAC or 100-240 VACInput Voltage Range ±10%Power Consumption Maximum 60 watts (120 VA) p

14 C313M-D (8/05)

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material orworkman

Worldwide Headquarters3500 Pelco WayClovis, California 93612 USAUSA & CanadaTel: 800/289-9100Fax: 800/289-9150InternationalTel: 1-559/292-1981Fax:

INSTALLATION ExSite ™ SeriesExplosionproofPower Module C313M-D (8/05) IPSXM-2 and IPSXM-7

C313M-D (8/05) 3 Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4 C313M-D (8/05) Important Safety Instructions 1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.

C313M-D (8/05) 5 Getting Started Thank you for purchasing Pelco’s ExSite ™ Series explosionproof integrated positioning system. This manual includes

6 C313M-D (8/05) Install the Power Module Attach the power module to the mounting surface. Use only installation methods and materials capable of sup

C313M-D (8/05) 7 Connect Wiring Refer to the following information to connect the wires and cables as required. NOTES: • Relay 3 is allocated spec

8 C313M-D (8/05) DIP Switch Settings Configure the receiver address, termination, and baud setting for the system. The DIP switches to configure these